Calibration of Beni-Mazar Movable Bed Model
A sand-bed model representing a reach of the Nile River was constructed to study alternative solutions to maintaining the navigation channel. Flume tests were carried out first to determine...

Fluvial Recharge of Sand Mining Pit
Accuracy in modeling fluvial processes becomes increasingly important as development occurs along waterways. The FLUVIAL-12 (1, 2) model is used to simulate the recharge of sand mining...

Development of Method for Measuring Near-Surface Turbulence
New techniques for tracking particles in fluid are presented. A method to make micro-capsules which are filled with pure water and covered with a thin film of polystyrene is developed....

A Low Pass Filter for Incident Detection
A new algorithm for automatic incident detection was developed after observing that existing algorithm performance can improve if detector data are filtered before use. The new algorithm...

A New Approach for Real-Time Prediction of Traffic Demand-Diversion in Freeway Corridors
An adaptive method is developed for real-time prediction of demand and diversion of traffic flow at on-ramp areas of freeway corridors. The prediction method explicitly treats the time-variant...

Slow Sand Filtration
This report, Slow Sand Filtration, was prepared by the Task Committee on Slow Sand Filtration of the Water Supply Committee of the Environmental...

Identification of Bilinear Severely Hysteretic Systems
An identification method is investigated on bilinear severely hysteretic systems subjected to a strong earthquake motion by means of the Extended Kalman Filter incorporated with a weighted...

Parameter Identification and State Estimation of Structure Models in Shaking Table Test
In this paper physical parameters and inner states of structure can be estimated from the input and responses in shaking table test by means of Extended Kalman Filter (SIEKA). Comparing...

Damage Assessment of Bridge Structures by System Identification
A method for the damage estimation of bridge structures under seismic ground excitation is developed based on system identification approach. The dynamic behavior of a damaged structure...

A Plant for All Seasons
Collins, Eckley and Detweiler describe a successful energy conservation program at the Willow Lake Wastewater Treatment Plant, Salem, Ore. By funding the $4.59 million project with a combination...

Artificial Recharge in the Southern Ogallala?Experiences with Playa Lake Water and Filter Underdrains
Ground water in southern portions of the Ogallala Aquifer has declined significantly over the past several years. Attempts to recharge playa water in the past have failed due to the clogging...

The Influence of Uniformity on Riprap Stability
Studies have shown that size uniformity influences the stability of riprap. The ratio of fractional sizes of the riprap mixture, D60/D10,...

Sediment and Aquatic Habitat Associations in River Systems
This paper results from the Task Committee's effort to summarize knowledge linking sediment transport and aquatic ecology. This paper presents one element of this work: the...

Slurry Removal From a 2-D Fluidized Region
A two-dimensional fluidization experiment is performed on fine sand with a 5.08 cm diameter source pipe with horizontally opposed orifices, 0.317 cm in diameter, spaced 5.08 cm. Slurry...

Reliable Displacements from Integrated Quick-Release Accelerograms
A new baseline correction method has been developed which allows accelerograms collected during quick-release tests of full scale structures to be doubly integrated to displacements. The...

Real-Time and Off-Line Aids for Teaching Digital Control
This is a report of unique computer tools developed for teaching of the design of digital control systems at the University of Wyoming. The real-time components of the laboratory involve...

A Method for Design and Evaluation of Rapid Sand Filters Treating Secondary Effluents
The information presented in this paper provides a framework for analysis of rapid sand filter performance. Process variables are quantitatively related to filter design variables in a...

Full-Scale Evaluation of Filter Influent Chlorination and Ozonation
Ozone and chlorine applied ahead of pressure filters are compared to determine the effect of the chemical addition on the pressure differential across the filter bed. The study was significant...

Design and Construction of Slow Sand Filters
The belief that large area requirements are necessary is based on old concepts and contemporary engineering designs that overstate area requirements. Large area requirements result from...

Biological Phosphorus Removal Using a Fixed and Suspended Growth Combination: A First Year Appraisal
As an alternative to the activated sludge process for biological phosphorus removal, this paper discusses an alternative which avoids high costs of air supply and large suspended growth...

 

 

 

 

Return to search